icon98.5% available from stock
iconYou can reach us till 6 PM
iconReal time stock level check
iconOrdered before 7 PM, shipped today

Phantom solid carbide thread milling cutters

Tip Trick
Tapping

Phantom, the premium Dutch brand of machining tools, is broadening its offer with a range of solid carbide thread milling cutters. These tools are available in three models: in addition to the standard version, there is a coated thread milling cutter with a coolant feed and a special thread milling cutter which creates the phase as well as the thread.

Best option

In many applications a Phantom tap, is a better solution. Thread milling is often the best option for thread creation in more difficult materials, larger diameters or unmanned production. The reduced risk of breakage, in particular, is a major advantage, especially in unmanned production. Thread milling is even preferable when creating a thread in very accurate workpieces, because the offset allows much better control of the dimensional accuracy than is possible with taps. For blind holes, the maximum thread length can be measured very accurately. In practice, thread milling has the advantage that you can mill several diameters with a single thread milling cutter as long as the pitch of the thread remains the same. This means that you can reduce the number of different tools in stock.

3 models

The demand for good thread milling cutters is growing. Phantom is therefore launching a complete range of solid carbide thread milling cutters for different applications. The basic model is a solid carbide Micrograin 2xD thread milling cutter in an uncoated finish. This tool is particularly suitable for occasional thread milling. The second model is the thread milling cutter with a TiCN coating which has two internal coolant feeds. This tool is also supplied in 2xD. The coating and internal cooling give better chip removal from the hole. This model is a typical thread milling cutter for production applications. An extra tool change is normally required to create a phase. This is not necessary in the third version of the Phantom thread milling cutter which has a phase for chamfering the edge. This cutter is also coated and has internal cooling. Phantom thread milling cutters are available with a pitch of 0.5 to 2.5 and for all current metric thread types.

 

26.310 26.310

26.31626.316

26.384 26.384

Sign up as a customer

  • 98.5% available from stock
  • You can reach us till 6 PM
  • Real time stock level check
  • Ordered before 7 PM, shipped today

Call us during office hours (08:00 - 18:00)
Questions?

Phantom B.V.
Voorste Kerkweg 4
7361 ET Beekbergen
Postbus 28
T:00800-7426866
E:info@phantom.com

The cart is empty.